Company: Contact: Job Name: Mark #: TRUDOOR, LLC 4737 N. 43RD AVE #6 PHOENIX, AZ 85031 P: (623) 748-9122 F: (623) 547-7052 [email protected] Email Address: Phone Number: Fax Number: Replacement Door Worksheet A DOOR TYPE: _____ HOLLOW METAL, 18 GA. _____ SOLID CORE WOOD (VENEER: ____________ ) _____ OTHER: ___________________ C ___________________ A. INSIDE DIMENSION OF FRAME WIDTH (e.g. 36”) D Measure from the inside of the frame head, to the top of each hinge cutout ___________________ B. ACTUAL DOOR HEIGHT (e.g. 83 1/8”) G ___________________ C. UNDERSIDE OF FRAME HEAD TO TOP OF HINGE CUTOUT #1 F E H B Note: 8’0” doors have a 4th hinge (not shown on drawing). Write 4th hinge dimension in the notes/additional info box. ___________________ ___________________ ___________________ ___________________ ___________________ ___________________ ___________________ ___________________ D. UNDERSIDE OF FRAME HEAD TO TOP OF HINGE CUTOUT #2 E. UNDERSIDE OF FRAME HEAD TO TOP OF HINGE CUTOUT #3 F. UNDERSIDE OF FRAME HEAD TO C/L OF FRAME LOCK PREP G. UNDERSIDE OF FRAME HEAD TO C/L OF DEADBOLT CUTOUT H. LOCK BACKSET (e.g. 2 3/4” or 2 3/8”) I. DOOR THICKNESS (e.g. 1 3/4” or 1 3/8”) J. HINGE HEIGHT (e.g. 4 1/2”) K. DOOR HAND FIRE RATING:_____ 20 _____ 45 _____ 60 _____ 90 _____ 3 HR LITE KIT (EXPOSED GLASS): _____ NONE _____ 10” X 10” Measure from the inside of the frame head, to the center-line of the strike or lock cutout _____ 5” X 20” _____ 4” X 25” _____ 22” X 28” HALF GLASS _____ FULL GLASS OTHER: _________________________________ LOUVER SIZE: _____ NONE _____ 12” X 12” _____ 12” X 24” Typical Undercut: 3/4” or 5/8” _____ 24” X 24“ _____ FULL LOUVER _____ OTHER:_____________ K RH OUTSIDE (KEYSIDE) RIGHT HAND RHR OUTSIDE (KEYSIDE) RIGHT HAND REVERSE HARDWARE: _____ HINGES (TYPE:______________ ) LH I _____ LOCKSET (FUNCTION:____________ ) _____ DEADBOLT _____ PANIC BAR (TRIM:____________ ) _____ DOOR CLOSER _____ PUSH/PULL SET_____ LATCH GUARD _____ KICKPLATE _____ THRESHOLD_____ WEATHERSTRIP _____ DOOR SWEEP _____ DRIP CAP_____ WALL/FLOOR STOP _____ DOOR VIEWER OUTSIDE (KEYSIDE) LH - LEFT HAND LHR OUTSIDE (KEYSIDE) LEFT HAND REVERSE The hand of a door is always determined from the outside. J HARDWARE FINISH: _____ US26D _____ US32D _____ US4 _____ US3 _____ US10_____ US10B _____ OTHER: _____________ NOTES / ADDITIONAL INFO: _______________________________ ______________________________________________________________ ______________________________________________________________ ______________________________________________________________ © Trudoor, LLC | 10/2014