DRIVELINE HiTEC® 475 Automatic Transmission Fluid Package Designed to Meet Ford’s M2C33-F (Type F) and M2C33-G (Type G) ATF Specification Requirements DRIVELINE HiTEC® 475 Automatic Transmission Fluid Package Designed to Meet Ford’s M2C33-F (Type F) and M2C33-G (Type G) ATF Specification Requirements Recommended Dosage The recommended treat-rate for HiTEC® 475 additive is 7.65% wt. in good quality base stocks for Ford Type F and Ford Type G Automatic Transmission Fluid applications. Please contact your Afton Chemical representative for specific recommendations. Typical characteristics Appearance: Yellow viscous liquid Density at 15.6 °C, g/ml: 0.902 2 Kinematic Viscosity at 100°C, mm /s:198 Flash Point (PMC), °C: 125 min Friction Graph Depicting the Difference between DEXRON® and Ford Type F & G The coefficient of friction at point (A) on the Ford fluid is up to 50% higher than for a DEXRON® III at point (B). (B) Engagement Time Low static friction, typical of DEXRON® type fluid NOTE: The friction curves are not drawn to scale Handling Information Max Handling Temp: 60°C Shelf Life: 24 months at ambient For d M2 C33 -F a Volv nd o9 -G 733 0 Approvals Product HiTEC® 475 ATF Specifications 3 Product Status Meets Requirement (A) Friction Torque HiTEC® 475 additive package is specifically developed to meet the Ford M2C33-F (Type F) and M2C-33-G (Type G) Automatic Transmission Fluid Specifications. Fluids meeting these ATF specifications are not friction modified and are classified as “high static friction” fluids. They are required in Ford automatic transmissions built between 1976 and 1981, where Type F and Type G fluids are specified. ATFs based on HiTEC® 475 can also be used in power steering and automatic transmission systems where Volvo 97330 is specified. Friction Torque Key Performance Benefits 3 Specification Status 3 Obsolete © 2015. Afton Chemical Corporation is a wholly-owned subsidiary of NewMarket Corporation (NYSE:NEU). HiTEC® is a trademark of Afton Chemical Corporation. 01/15. The information in this bulletin is, to our best knowledge, sure and accurate, but all recommendations or suggestions are made without guarantee since the conditions of use are beyond our control. Afton Chemical Corporation and its affiliates disclaim any liability incurred in connection with the use of these data or suggestions. Furthermore, nothing contained herein shall be construed as a recommendation to use any product in conflict with existing patents covering any material or its use. Engagement Time High static friction typical of Ford M2C 33-F&G fluid
© Copyright 2024