45LT-CN Series Torque ajustment screw side Sticker side Torque ajustment screw Terminations BLACK GRAY GREEN YELLOW BLUE RED Torpue ajustment screw Lineups Torque up (CW) , Torque down (CCW) Plea se turn it by light power. Plea se employ an M2 Phillip s driver. Heavy, and a place to fall into i s the limit of the turn. CF-45LT-CN1 - Cross fader Vestax PMC 05 06 07 007 - * Installation plate and knob are not included. How to use Specifications (Fader) CF-45LT-CN1 M3 Sc rew Installation plate 2LPA-4805LT-B50K Number of circuit Total resistance Total resistance tolerance Taper Linearity Residual resistance Voltage proof Insulation resistance Max rating Sliding noise level Sticker side Torque aju stment screw side GRAY RED YELLOW GREEN BLACK BLUE TOKYO KO-ON DENPA CO., LTD. GRAY and RED YELLOW GREEN BLACK and BLUE 1. Adjust it to favorite torque. 2. Fix an installation plate to the fader with an M3 screw. 3. Connect the connector of the mixer and a connector of CF-45LT. 4. Put fader in a mixer and fix it with a screw. 5. Cover with the face panel of the mixer. 6. Attach a knob. *An installation board, a screw, a knob are things using now, or, please prepare separately. www.tkd-corp.com EDF-201502 The products and their specifications are subject to change without notice. Sliding life Stroke length Operating force Strength of Nut-Attached Attached Parts Stopper strength Push-pull strength Temperature range Relative humidity 2 50kohm (Red-Blue, Black-Gray) ±20% Linear (Potentiometer circuit) ±5% 5ohm or less Red-Yellow, Blue-Yellow Black-Green, Gray-Green 1 Min. at AC500V 50Mohm or more at DC250V DC20V 47mV or less (by JIS C 6443) 100,000 Cycles Min. Cycle speed: 18cycles/min Sliding noise level: Less than 100mV 45mm±0.5mm 0~0.5N (Torque adjustment screw) 100Ncm M3 screw 50N 50N -10 to +60 degrees C (Operating) -15 to +65 degrees C (Storage) 80%RH (No condensation)
© Copyright 2024