TrendView Recorders - Installation Instruction Screen Protectors QX Recorder SX Recorder QXe Recorder DR Graphic Recorder The screen protectors can be applied at any time with the recorder either powered or unpowered. However fitting a screen protector when a recorder is powered may cause activation of the touch screen with unintended results. It is advised that the power is removed before fitting. Dust and lint will be the biggest problem when applying the screen protector. It will help to be working in as clean an environment as possible. Clean the surrounding area and the recorder screen before starting. The pictures in the instructions below, all show fitting a screen protector to an SX recorder. Exactly the same procedure should be used for the QX, QXe and DR Graphic recorder. 43-TV-33-78 iss.3 GLO Dec 14 UK 1 Removing an existing screen protector If a screen protector is already fitted to a recorder then it must be removed before fitting a new one. Carefully lift the edge of the protector and gently peel off. This can now be discarded. When trying to pick up the edge do not use anything sharp that may puncture, cut or damage the touch screen. Fitting a screen protector The adhesion/silicon layer is covered with a thin, shiny plastic film. The front side is also covered with a protective film, this should be left on until the screen protector is fitted. The main problem when fitting a screen protector is air bubbles under the protector. These are often caused by dust and dirt on the recorder screen. Using a lint free cloth carefully clean the recorder screen. If a dry cloth will not clean the screen then water may be used sparingly. Wipe the screen protector to make sure there is no dirt or dust attached. Expose the silicon/adhesion layer along one edge by peeling back about 1 inch (25mm) of the backing. (Avoid touching the adhesion layer as this may leave fingerprints) If you have trouble removing the backing film, apply a small piece of adhesive tape to one corner to help remove the backing film. Align the screen protector with the edge of the recorder screen and push into place by applying light pressure. Smooth it across the screen. A credit card or similar may be used to help smooth it down. Gradually pull off more of the backing and continue to apply pressure to the screen protector gradually moving across the screen. If you notice bubbles as you go, gently pull the protector back and retry. If the bubble is cause by dust or dirt try to clean it off before retrying. Once the screen protector is in place the protective film from the front can be removed Copyrighted Materials. For more information please contact your supplier. 43-TV-33-78 iss.3 GLO Dec 14 UK 2
© Copyright 2024