Product code Inmould Graphic Specifications - Universal 2 aquaBUBBLER with Dog Bowl AB2UA14D aquaBUBBLER Pantone PMS colour matches Artwork Criteria The process that is used to make the Inmould graphic is very similar to screen printing, as used on T-shirts and some posters. Each colour used in the artwork is layered on a clear film sheet. The clear film sheet is then placed inside the rotomould when the aquaBUBBLER body is manufactured. Polymer colouring does not use PMS or CMYK colours in the process, but our specialist colour-matches to your specified PMS colours. The cost of each graphic depends on its size and the number of colours used. Sunset Yellow Aqua Chilli Red Denim Blue Olive Green Charcoal Grey Rich Blue Gumleaf Green 3955C 3272C 032C 7545C 375C 432C 2935C 554C Artwork Example Pacific Blue 2995C Tiger Orange Deep Purple 021C Violet C Custom Colours New Colour: Corella White Cool gray 1U Artwork Sizes and Locations Supply artwork in Vector (paths) format with proof PDF indicating the PMS or CMYK colours used. NOTE: Graduated fills are unable to be reproduced, each colour MUST be a solid block. The above artwork contains 6 spot colours . . . magenta, white, black, green, yellow and purple NOTE: the light blue (cyan) is the colour of the aquaBUBBLER body NOTE: avoid small hairlines and complicated detail Le ft S i d e 125mm wide x 500mm high Right Side Rea r 125mm wide x 500mm high 125mm wide x 500mm high NOTE: The above dimensions are maximum print area. If required, smaller artwork /graphics can be used 1300 213 774 www.aquabubbler.com.au 0800 213 774 www.aquabubbler.co.nz