FORM ROLL-OVER BRAKE Simplify Stripping Features: n Strip forms faster n Improve plant safety n Eliminate dangerous swinging of forms Each pair of brakes can handle forms weighing up to 10 tons. Brakes are simple to install making it easy to share between forms as needed. The new brake device reduces the dangerous swinging motion by 85 – 90% when the form is rolled over. The Form Roll-Over Brake rolls over any precast form poured with a bottom. The brake speeds up the stripping process as the brake is used to turn the form 180 degrees at a controlled rate of speed. Plant personnel determine the brake’s level of resistance for each form to provide the optimum level of safety and efficiency when stripping. 0215-250 For better viewing, all guards, safety devices and signs are not necessarily shown. Some of the equipment shown or described throughout this brochure is available at extra cost. Besser Company reserves the right to change or improve product design and specifications without prior notice. Since the time of printing, some of the information in this brochure may have been updated, ask your Besser sales representative for details. 801 Johnson Street Alpena, Michigan 49707 USA +1.989.354.4111 [email protected] besser.com