GOVERNMENT OF INDIA DEPARTMENT OF ATOMIC ENERGY

GOVERNMENT OF INDIA
DEPARTMENT OF ATOMIC ENERGY
DIRECTORATE OF CONSTRUCTION, SERVICES AND ESTATE MANAGEMENT
CHIEF PROJECT ENGINEER (MECHANICAL)
4th floor, Vikram Sarabhai Bhavan, Anushaktinagar, Mumbai – 400 094
e-Tender - FINANCIAL BID
NIT No.: DCSE/CPE (M)/Telephone/AMC/47/13-2014 dt. 10/06/2013
SCHEDULE OF QUANTITY
Name of work :- Rennovation/upgradation and biennial maintenance contract for telephone network system under DCSEM at
Anushaktinagar,Mumbai -400094
NAME OF THE CONTRACTOR
Sl. No.
1
2
2.1
2.1.1
2.1.2
2.1.3
2.1.4
2.1.5
2.1.6
2.1.7
2.2
Description
Qty.
Unit
Rate
Preventive, breakdown maintenance of telephone network as per Clause No:- 1 of additional technical
specification. (refer technical bid).
Job/qtr
Supply installation, testing & commissioning of the following :
Terminal boxes, telephone chords etc.
RJ-11 telephone socket of model no. 6745 21 (Mosaic) of M/s Legrand make.
each
50
White cover plate 1-module model no. 6745 51 (Mosaic) of M/s Legrand make
White cover plate 2-module model no. 6745 51 (Mosaic) of M/s Legrand make
each
each
25
10
Plastic surface box 1/2 module 6745 46A (white colour) of M/s Legrand make
each
Coiled telephone chord (approx. 0.5m) with RJ-11 connectors crimped at both ends including interconnection of the
same with
the base unit & handset.
each
Single pair telephone chord (approx. 2m) with RJ-11 connectors crimped at both ends including interconnection of
the same
with the telephone connector box & telephone instrument.
each
50
Telephone connector box with one no of RJ-11 telephone socket
Analog telephone instrument with caller ID facility Panasonic KX-TSC62SX model or superior model or equivalent
make and model of Alcatel/Avaya/Tadiran
Note :
i) All instruments supplied must be guaranteed & maintained free of cost till the completion of contract. Defective
instruments must be replaced with new instruments wherever required.
ii) Stock of 10 analog instruments shall be maintained through out the contract period.
Amount in Rs.
0
8
0
0
0
0
0
100
0
100
each
100
each
200
0
0
Page 1 of 4
Sl. No.
Description
2.3
Disconnection modules, ready made junction boxes etc. Note: 1) Scope includes dismantling of existing
TTB/feeder pillar/disconnection module and retermination of existing cables, if required. 2) Existing CT box can be
utilised with the approval of E-I-C, if in good condition .
2.3.1
10 pair disconnection module of M/s ADC Krone (Schneider) make part no. 6901100602 including dismantling the
existing damaged 10 pair modules & re-termination of the wires on the new module.
Qty.
Unit
Rate
0
each
50
2.3.2
10 x 10 pair disconnection modules of M/s ADC Krone (Schneider) make part no. 69001100602 along with acrylic
covers,
mounting arrangement & installation of the same in termination of wires.the existing MDF/TTB etc. including
termination of wires.
2.3.3
2.3.3.1
2.3.3.2
2.3.3.3
2.3.3.4
2.3.3.5
2.3.3.6
2.3.4
0
each
10
Telephone junction box
Telephone junction box of suitable size made out of MS CRCA sheet, powder coated, gasket and locking
arrangement,
having SS back mount frames, wherever required, etc.of complete with termination of wires etc. all as required &
directed containing disconnection modules of M/s Krone make part no. 6901100602 with acrylic cover of the
following sizes of Junction box make of M/s ADC Krone(Schneider)/ITL make complete with all mounting
aceesories as required as per instructions of E-I-C:
0
each
6
each
each
each
each
each
6
4
4
2
2
100 pair Feeder Pillar box for external use made out of 3 mm thick MS CRCA sheet totally weather resistant,
outdoor type, dust,
water & rust proof, duly powder coated with rubber gasket on door, locking arrangement, weather proof canopy
etc. of M/s ADC Krone(Schneider)/ITL make containing disconnection modules of M/s ADC Krone (Schneider)
part no. 6901100602 with acrylic cover of the following sizes complete with all mounting aceesories including
dismantlihg of existing feeder pillar and agle iron framework, welding, painting etc, if required, as per instructions of
E-I-C:
each
4
Telephone junction box 20 pair
Telephone junction box 50 pair
Telephone junction box 100 pair
Telephone junction box 200 pair
Telephone junction box 600 pair
Amount in Rs.
0
0
0
0
0
0
2.4
Telephone wires
2.4.1
2 pair, pvc insulated, 0.5mm dia. annealed solid copper conductor telephone wires of M/s Delton / Finolex make in
existing PVC
casing capping / conduit/in open etc.
0
m
3000
Page 2 of 4
Sl. No.
2.5
2.5.1
2.5.1.1
2.5.1.2
2.5.1.3
2.5.1.4
2.5.2
2.5.2.1
2.5.2.2
2.5.2.3
2.5.2.4
2.6
2.6.1
2.6.1.1
2.6.1.2
2.6.1.3
2.6.1.4
Description
Qty.
Unit
Rate
Amount in Rs.
Telephone cable
0.5 mm dia. annealed solid conductor, colour coded & twisted pair polyethylene insulated, PVC sheathed, fully jelly
filled, GI wire/strip armoured telephone cable of the following sizes, in existing hume pipe / trench etc. /over surface
with 4 mm thick hot dipped GI spacer and 16 SWG thick hot dipped GI saddles fixed at a distance of 350 mm from
each other with screws and PVC phil plug etc. etc.minimum no. 10 x 35 mm GI wood screws etc.
10 pair
m
300
0
0
20 pair
m
50 pair
m
100 pair
m
Same as in item no. 2.5.1 but in ground including earth excavation including soft rock 500mm wide and 600 mm
deep complete with sand bedding and brick protection and refilling as required as per standards and instructions of
E-I-C: Note: Measurement of hard rock excavation will be done separately.
300
300
150
10 pair
20 pair
m
m
300
500
50 pair
m
200
0
0
100 pair
m
150
0
0
0
0
0
Cable jointing, end termination etc.
Providing straight joints for PJF armoured telephone cable with M/s Raychem make jointing kit complete with all
accessories for cables of the following sizes.
10 pair
each
6
20 pair
each
6
50 pair
each
4
0
0
100 pair
each
4
0
10 pair
each
20
0
20 pair
each
20
0
50 pair
each
10
0
100 pair
each
6
0
2.6.2
End termination of PJF armoured telephone cable with M/s Raychem make end termination kit complete with sizes.
2.6.2.1
2.6.2.2
2.6.2.3
2.6.2.4
2.7
2.7.1
2.7.2
2.7.3
2.8
2.8.1
2.8.2
2.9
3
PVC casing capping (white) of following sizes on surface of slab / wall / column fixed with nylon rawal plug, GI
wood screws at intervals of 300mm included providing the tags for wires inside casing capping for bunching to
avoid hanging of wires at the intervals of 600mm.
0
25x16 mm
m
200
38x25 mm
m
20
0
50x50 mm
m
20
0
m
m
m
100
200
150
G I Pipe
50mm dia Class B GI pipe laid in existing trench etc. with proper fixing / mounting.
50mm dia. Class B GI pipe fixed over the wall / surface etc. with GI clamp, coaches screws etc.
150mm dia. RCC Hume pipe laid in existing trench with wooden bushes etc
Excavation
0
0
0
Page 3 of 4
Sl. No.
3.1
3.2
4
4.1
4.1.1
4.1.1.1
4.1.1.2
4.1.2
4.1.2.1
4.1.2.2
4.2
5
6
7
8
9
10
10.1
10.2
11
Description
Qty.
Cutting of Shahabad stone / footpath/ road cutting (of thickness upto 10 inches) including refilling / reinstatement of
the excavated portion after completion of work, complete all as required.
Sqm
Excavation in hard rock/ PCC, including reinstatement of the excavated portion after completion of work, complete
all as required.
Cum
Installation, testing & commissioning of the following departmental supplied cable / wires.
Armoured PJF telephone cable
50 pair
In exiting hume pipe / trench etc
m
Over the wall / surface with 4 mm thick hot dipped GI spacer and 16 SWG thick hot dipped GI saddles fixed at
intervals of 350 mm from each other with minimum no. 10 x 35 mm GI wood screws and PVC phil plug etc.
100 pair
In exiting hume pipe / trench etc
Over the wall / surface with 4 mm thick hot dipped GI spacer and 16 SWG thick hot dipped GI saddles fixed at
intervals of 350 mm from each other with minimum no. 10 x 35 mm GI wood screws and PVC phil plug etc.
G.I. wire / PVC insulated aluminum wire
Identification of the telephone nos. in existing MDF / TTB preparation of laminated chart indicating the telephone
no, tag block no. etc. compete all as required & directed.
Locating fault in 10P / 20P / 50P / 100P PJF armoured telephone cable laid in ground.
Unit
0
50
150
m
50
m
150
m
m
50
1000
4
10
Each
Each
50
30
Supply and installation of cable marker embossed with “ DCSEM TELEPHONE CABLE” with 25/32 mm GI pipe.
Each
Painting with 2 coats of enamel paint of approved colour and labeling with black enamel paint all as per instructions
of E-I-C
Painting of existing TTB (indoor)
Each
Painting of existing Feeder pillar(outdoor)
Each
20
Reparing of TTB/Fedder pillar doors by welding /providing new hinges in place of existing damaged /rusted
hinges/reparing of PCC with all the required material.
Each
Amount in Rs.
0
250
Job
Job
Repairing of defective telephone instruments of various models of Beetel / Tata Fone etc. make & making it
functional by repairing / replacing the defective part.
Replacement of defective panel lock of TTB / FP with new panel lock.
Rate
30
10
0
0
0
0
0
0
0
0
0
0
0
0
0
0
10
TOTAL
TOTAL REBATE IN PERCENTAGE ( IF ANY)
GRAND TOTAL AFTER REBATE
0.00
0.00
0.00
Page 4 of 4