11235 West Bernardo Court, Suite 102 San Diego, CA 92127 888-880-1880 Fax: 707-281-0567 EnvironmentalLights.com How to Connect MaxLite Plug-and-Play to 120 VAC Wiring Safety Precautions Please take the following general precautions when installing any sort of LED lighting: 1. This equipment, like all electrical equipment, should be installed by a qualified professional who should have the tools and knowledge of the trade. 2. Never wire systems with the power on because you may damage the LEDs or equipment by creating current spikes. Always shut the power off before making connections. 3. Do not expose LEDs, controllers or other electronics to intense electro-magnetic fields, including lightning. 4. These products are not waterproof. Keep them dry. Installation Instructions To connect your MaxLite Plug-and-Play LED light bar installation to standard 120 VAC wires, also commonly known as Romex® wires, follow the procedures below: 1. Trim the 120 Volt Bar to Power Connector cable, MLSDLBJL70, to the desired length for installation. The Bar to Power Connector cable is 70 inches in length and has a line (black), ground (green), and neutral (white) wire. 2. Connect the power connector to the light bar. Using a junction box with the light bar installation will help contain the connections of the line voltage or low voltage wires. The 120 Volt Shallow Junction Box, JBOX-P, is grey and plastic. The MaxLite Lightbar Connection Box, MLSDLBCONNSW, is white, plastic and includes a cover. 3. Insert the Romex® wires into one end of the desired junction box, using one of the knock-out tabs on the box. 4. Insert the wire end of the MaxLite cable into the knock out at the opposite end of the junction box. 5. De-sheath and strip each wire on the Romex® wires and the MaxLite cable wires. Exposing at least 3/8’’ will help ensure MLSDLBJL70G that good contact is made between the wires. 6. Use wire nuts to connect the line wires together, the ground wires together, and the neutral wires together. Make sure that each connection is secure and correct. 7. Mount the junction box in the desired secure location using the available mounting holes. JBOX-P 3.75’’x 2.31’’x 1.25’’ Copyright EnvironmentalLights.com MLSDLBCONNSW 3.75”x 2.31”x 1.25” All Rights Reserved 7/2/14