EASY SETUP GUIDE FOR YOUR DX-250 MODEM 1 STEP 1: CONNECT Connect your modem to your computer using the ETHERNET cable provided and plug in the power cord into a outlet. STEP 2: REGISTER ACCOUNT When the green signal lights become steady, open a browser and web self care will automatically open or enter http://selfcare.digicelbroadband.com into the address field of the browser. Use your web self care portal to register. You may start browsing while connected using the ethernet cable or proceed to step 3 to setup Wi-Fi. 2 STEP 3: SETUP WI-FI Open a web browser on your computer • Enter URL in web browser: 192.168.100.1 • Enter username: user • Enter password: user • Log into the user interface (Click “Login”). • Click “Networking” STEP 4: FIND THE DEFAULT WI-FI NETWORK NAME AND SECURITY KEY • On the Wi-Fi page, click next at the bottom of the page. • The default* Wi-Fi name/SSID is located under “Common Setting”. Example: “Digicel-000000” • The default* security key/Wi-Fi password can be found under “Security Setting”. “Example 0000000000” *Default Wi-Fi access codes are unique to each device. 3 STEP 5: PERSONALISE WI-FI NETWORK (OPTIONAL) You can personalise your DX-250 modem by changing the default Wi-Fi access codes. To do this, simply: • Select “User Defined” from Use Default drop down box. • Change Wi-Fi network name by »» Editing default SSID. • Change default security key by doing the following »» Change Security mode from “WEP” to “WPA-PSK”. »» Edit shared key (WPASK) to your desired Wi-Fi password. • Click “Apply” • You will be redirected to the login window if configuration was successful. If you have anymore questions about personalising your DX-250 modem, call 142 from your Digicel phone. 4