Download Report

116 Research Dr.
Bethlehem, PA 18015
Phone: (484) 661 – 1572
Fax: (484) 244-7122
E-mail: [email protected]
Website: www.sb-lighting.com
Installation Instructions for the LED Puck Light
WARNING
Risk of fire or electric shock. Install the transformer or dimmer control drawings
according to the figures below. Make sure turn off circuit breaker and disconnect
power to the dimmer or transformer. DO NOT SIMPLY SWITCH OFF SWITCH.
NOTE: This user guide is intended to be used as a reference only. Installation should be done by a fully qualified
electrician or technician. This document should never be considered as a substitute for any provision of a
regulation or state and/or local code. Please read the entire user guide to fully understand and safely use this
product. ***** Specifications are subject to change without notice*****
SunBound- All Rights Reserved
[email protected]
1|P a g e
116 Research Dr.
Bethlehem, PA 18015
Phone: (484) 661 – 1572
Fax: (484) 244-7122
E-mail: [email protected]
Website: www.sb-lighting.com
Recessed Mount
1: Remove the mounting ring and discard it.
2: Mark the location where the LED Puck light is
going to be recessed.
3: Drill out the marked location with a 2.5"
circular saw.
4: Feed the LED Puck light wires through the cut
out hole and snap the LED Puck light into the
hole.
5: Repeat the steps 1 through 4 for the remaining
pucks and then follow the "Power the Puck
Lights" steps.
Surface Mount
1: Remove the mounting ring.
2: Use the mounting ring as a template to mark
the screw location where the LED Puck light is
going to be installed.
3: Use a 1/16" drill bit to drill pilot holes on
marked locations.
4: Feed the LED Puck wires through the
mounting ring. Hold the cord against the notch
on the mounting ring while installing the
mounting ring to the pilot holes with the provided
two Phillips screws.
5: Pull the cord through the notch on the
mounting clip and snap the LED puck light into
the mounting ring.
6: Repeat the steps 1 through 5 for the remaining pucks and then follow the "Powering the Puck Lights" steps.
Note: Always pre-test your LED Puck Light assembly by making all connections and hooking up the Puck Lights to power. This will
ensure that all components are functioning properly before they are installed. Make sure that the 12V DC power supply is not
connected to live power before connecting or disconnecting the Puck Light installation’s components. Switch 120V house power off
at the circuit breaker before installing a 12V Driver and/or Dimmer Switch.
SunBound- All Rights Reserved
[email protected]
2|P a g e
116 Research Dr.
Bethlehem, PA 18015
Phone: (484) 661 – 1572
Fax: (484) 244-7122
E-mail: [email protected]
Website: www.sb-lighting.com
Powering the Puck Lights
Powering with a 12V Adapter:
After mounting the Puck Light, connect the power
cable to the 12V Adapter. If installing multiple Puck
Lights, connect all of their power cables to power
with the use of a DC Splitter Plug according to the
diagram above.
Powering with a 12V Dimmable Driver and dimming with a 120V Dimmer Switch:
After mounting the Puck Light, use a male Adapter
Splice (Wire Plug) to connect the Puck Lights to the
12V Dimmable Driver, according to the diagram
above. If installing multiple Puck Lights, connect all
of their power cables to power with the use of a DC
Splitter Plug according to the diagram above.
SunBound- All Rights Reserved
[email protected]
3|P a g e