CONFIGURING THE MODEM 1. Turn the computer on and open up a web browser (for example Internet Explorer). 2. In the ‘Address’ field type in 192.168.1.1 3. When prompted for a username and password type admin as the username and admin as password (this username allows you to access the routers interface). 4. This will take you to the ‘Quick Start’ page where you need to enter your Orcon username and password. The Orcon username needs to be in the format <username>@orcon.net.nz 5. Click Connect. 6. Once connected close the window and open up a new window to start browsing. If you have trouble with the setup process please call us on 0800 13 14 15. orcon.net.nz HOW TO INSTALL YOUR NEW BROADBAND MODEM Thank you for choosing Orcon In this box you’ll find your new Netgear modem. INSTALLING THE MODEM 2) Connect the router to the filter The image shows what the end result will be upon the completion of the set-up. Securely insert one end of the supplied phone cable into the filter port marked ‘ADSL’ and the other end of the cable in to the ADSL port on the router. View the label on the bottom of the modem. It identifies useful information such as Ethernet port, USB port and LED legends and default login information. Just follow the instructions below and you will soon be up and running with high speed Internet. Note: Incorrectly connecting your modem to the phone socket prevents the modem from connecting to the internet. 3) Connecting your telephone to the ADSL filter Connect your telephone in to the ‘Phone’ socket on your ADSL filter. BEFORE YOU BEGIN An ADSL filter is required for each telephone device plugged in to the same line as your broadband connection at the premise. LINE ADSL2 PHONE Please ensure you have the following contents. 4) Connecting your PC to your modem DM11Pv2 Modem Power adapter Locate the yellow Ethernet cable and connect one end of the Ethernet cable to the Ethernet port on the modem. Telephone cable ADSL2 ETHERNET CABLE Ethernet cable USB cable ADSL in-line filter/splitter PHONE LINE Connect the other end to the Ethernet port on the back of your PC (please refer to PC user guide or PC manufacturer if you are unsure where this is located). 1) Connect ADSL filter to wall socket ETHERNET CABLE Choose a good location for your router to be set up. PHONE CABLE You must connect an ADSL filter to every device in your home/office that uses the same telephone line as your DSL modem e.g. phones, faxes, SKY and monitored alarms. Make sure there is adequate space around the modem for ventilation and do not block the ventilation holes. If you fail to install an ADSL filter on all devices, you may experience noise while you are talking on the telephone and your internet connection may not work. The modem installation will take approximately 10 – 20 minutes. Important info: Ensure your internet service is active (you should receive a text and/or an email upon the completion of your Orcon connection) and you have the necessary username and password settings. ADSL2 Keep the modem away from heat sources and out of direct sunlight. LINE ADSL PORT 5) Power on the modem LINE ADSL2 ADSL filters prevent noise interference between your telephone wiring and your modem. PHONE WALL SOCKET PHONE 1. Near to the telephone wall socket that provides the ADSL service. 2. Near to a power point. 3. Near to your computer(s). Plug the modem power adapter into the power point. Insert the power cord into the power port of the modem (as shown in the image). Turn on the modem by pressing the power switch button. Note: Ensure you are using the power adapter that comes with the modem. POWER PORT POWER SWITCH