Foresee version 5.6.0 Instructions I

InstructionsCommercial Compressors
Danfoss Foresee program
version 5.6.0
Introduction
The Danfoss Foresee program is a selection and calculation tool, covering following compressor series:
• Danfoss scrolls for airconditioning
• Danfoss scrolls for heating
• Danfoss scrolls for refrigeration
• Danfoss inverter scrolls
• Maneurop reciprocating compressors
• Maneurop inverter reciprocating compressors
Minimum system requirements
• PC with Windows XP or Windows 7, and optional with Excel 2000 to 2010.
• VGA monitor with minimum resolution of1024 x 768 pixels
Installation and start-up
• Important note: If Foresee is already installed, please refer to the chapter ‘Uninstall’ page 3.
• Grant or adminstrator access for the installation of this software.
• Unzip the file ‘Install_Danfoss_Foresee_5_6_0.zip’ by right-click on the filename and ‘Extract’ on C disk.
• Click on ‘setup‘
Danfoss Commercial Compressors - FRCC.EI.011.C1.02 - October 20141
Instructions Danfoss Foresee Program version 5.5.0
• Click ‘OK‘
• Click on the icon
• Click ‘Continuer‘
• Process installation
• Installation of the software is done.
Danfoss Commercial Compressors - FRCC.EI.011.C1.02 - October 20142
• Danfoss Foresee is available in Start / Danfoss CC / Danfoss Foresee
Use
1. Select calculation
mode and unit system
Copy selection to
clipboard
2. Input data
3. Calculate
Output data Vapour
Injection related
4. Output data
Uninstall
• Before installation of new version of Foresee, it’s important to uninstall the old version.
Danfoss Commercial Compressors - FRCC.EI.011.C1.02 - October 20143
Instructions Danfoss Foresee Program version 5.5.0
• Select ‘Danfoss Foresee’ and click ‘Uninstall/Change’
• Click ‘Yes’
• Unistall is done
Further information
Datasheets with full technical data for all products are available from our Online Datasheet Generator (ODSG) at http://www.danfoss.com/odsg. For more
advanced calculations and selections and on Danfoss Commercial Compressors products as well as other products, please use the Danfoss Coolselector
program. Please visit our website http://cc.danfoss.com or http://www.danfoss.com for further information.
Danfoss Commercial Compressors, BP 331, 01603 Trévoux Cedex, France | +334 74 00 28 29
FRCC.EI.011.C1.02 - October 2014
© Copyright Danfoss | Commercial Compressors | 2014.10