| SCHÖNOX AB ® Product data sheet 8.09 Sealing and Uncoupling Layer membrane made of polyethylene and covered with a special fleece installed using Schönox iFix sealing adhesive for commercial and residential wet areas. Suitable for use under ceramic tiles and natural stones. Product characteristics MICODE EC 1PLUS: very low emission E h igh tensile strength c rack bridging properties rot proof w ater resistant impermeable to vapor fl exible easy to apply for interior and exterior use s uitable on screeds with floor heating systems c an be used as a separation layer Applications SCHÖNOX AB is a membrane for residential and commercial wet areas such as: i n heavy loaded commercial wet rooms (public shower rooms, therapy rooms in hospitals) i n residential wet areas (bathrooms and showers) i n swimming pools prior to installations of ceramic tiles. Officially approved for pool depth of 10 m / 32.8 ft. using the recommended SCHÖNOX Tile Adhesives. o n balconies and terraces in combination with the SCHÖNOX BALTERRA® -system. Substrates SCHÖNOX AB is suitable on: concrete and cement based substrates masonry (fully grouted) g ypsum substrates old substrates such as ceramic tiles, natural stones and terrazzo cement plaster, lime-cement plaster g ypsum plaster composite elements of polystyrene coated with mortar wall panels of leight weight concrete g ypsum board plywood, OSB boards Requirements of substrate ubfloors must be smooth, sound, clean, S dry and free of any contaminants which may hinder adhesion. S urface treatments or any “friable” areas of the subfloor must be mechanically removed back to a sound base and the substrate repaired with SCHÖNOX repair compounds as required. O ld water-soluble adhesives should be removed completely, old water-resistant adhesives should be mechanically removed as far as possible. The complete mechanical removal of cutback (i.e. grinding, sanding, blasting) can be hazardous as old cutback adhesive may contain asbestos. Do not sand or grind adhesive residue. Harmful dust may result. Inhalation of asbestos dust may cause asbestosis or other serious bodily harm. Please consult the adhesive manufacturer and all applicable government agencies for rules and regulations concerning the removal of flooring and adhesives that contain asbestos. Prime remaining adhesive residues accordingly. O ld floors such as ceramic tiles should be thoroughly cleaned and abraded. T he requirements of the relevant valid standards, guidelines and data sheets apply. P rime substrates following the product data sheet of SCHÖNOX iFIX. Recommended working method Technical data olor: grey C Sheet width: 1 m / 3.28 ft. Roll length: 10 m / 32.8 ft. Thickness: approx. 0.5 mm / 1/64“ Weight: approx. 280 g per m² / 0.06lb. per sq.ft. Temperature resistancy: -22°F up to 194°F Working temperature: +41 ° F Burst pressure: 3,9 bar / 56.57 psi sd-rate: > 60 m / 196.8 ft. UV-resistance: min. 500 hours of ut strips to size before using. C A pply SCHÖNOX iFIX using the SCHÖNOX iFIX ROLLER 180 mm and insert the sheet membrane SCHÖNOX AB into the fresh adhesive. S CHÖNOX AB can be laid, within the open time of approx. 15-20 minutes into the fresh bed of sealing adhesive. Afterwards press SCHÖNOX AB gently using the SCHÖNOX iFIX TOOL avoiding air bubbles beneath. T he SCHÖNOX ST SEALING TAPE and the SCHÖNOX ST-COMPONENTS are installed beforehand with SCHÖNOX iFIX using the SCHÖNOX iFIX ROLLER 100 mm. E xpansion joints as well as floor and wall connection joints are bridged, drains and pipe are sealed using the SCHÖNOX ST Accessories as required. The overlappings are at least 5 cm. To guarantee the function of the membrane, this procedure must be carried out carefully. Packaging 10 m 2 / 105 sq ft. Storage tore horizontal in cool, dry conditions S avoiding any deformation. S helf life: 2 years Disposal S CHÖNOX AB is harmless and does not need P-5121/802/11-MPA BS P-5180/861/11-MPA BS | SCHÖNOX AB ® to be disposed as hazardous waste. Dispose of in accordance with federal, state and local waste disposal regulations. VOC Content 0g/l (calculated), SCAQMD 1168 LEED ay help contribute to LEED certification of M projects in the categories: E Qc2 Low-Emitting Materials – 1 to 3 points Instructions Always install an adequate number of properly located test areas to include the finish flooring, to determine the suitability of the product for its intended use. As ceramic tile coverings vary, always contact and rely upon the manufacturer for specific directions such as maximum allowable moisture content, adhesive selection, and intended end use of the product. Low substrate temperatures and/or high ambient humidity require longer drying times for primers. Product data sheet 8.09 The applicable recommendations, guidelines, regulations and safety data sheets are to be obser ved, together with the recognized architectural and engineering regulations. We guarantee that our products leave the factor y in perfect condition. While our recommendations for use are based on tests and practical experience, they can only provide general guidance without any assurance as to product characteristics, since we have no influence over the conditions on site, the execution of the work or the method of processing. This product data sheet supersedes all previous editions. Limitation of Liability The SCHÖNOX management system is certified to ISO 9001 and 14001 by DQS. SCHÖNOX GmbH P.O. Box 11 40 D-48720 Rosendahl/Germany Phone +49 (0) 2547-910-0 Fax +49 (0) 2547-910-101 [email protected] http://www.schonox.us In North America provided by: HPS North America, Inc Phone:256.246.0345 Fax:256.246.0346 Email:[email protected] http://www.hpsubfloors.com B _0809us_14-08 To the best of our knowledge, the technical data contained herein are true and accurate at the date of issuance but are subject to change without prior notice. We guarantee our product to conform to the specifications contained herein. We make no other warranty or guarantee of any kind, express or implied, including merchantability and fitness for particular purpose. Liability, if any, is limited to replacement of the product or refund of the purchase price. Labor or cost of labor and other consequential damages are hereby excluded. SCHÖNOX does not authorize anyone, including SCHÖNOX representatives, to make any statements which supersede, modify or supplement the information provided on its printed literature or package labels without written confirmation.
© Copyright 2024