Off the Beaded Path Delightful Drops Wrap Bracelet By: Kelly Dale of Off the Beaded Path April 2015 Materials List: *26 inches of .018 49 Strand Beading Wire *100 Top Drilled Tear Drop Beads *30 11/0 Seed Beads *98 8/0 Seed Beads *(2) 2x2mm Crimp Tubes *12mm Button *Crimp Pliers & Cutters *Please read this entire pattern before beginning the project. *I used a 12mm Swarovski Button but you can use any button that you may have on hand, you will just have to adjust the seed bead loop. *I used tear drops for this project but you can use any beads to make this wrap bracelet. 1. On your beading wire thread on one tear drop and one 8/0 repeatedly until you have all beads added. 2. At the very end of your wire thread on one crimp tube and 24 11/0’s. Go back down through the crimp tube and using your crimp pliers, crimp the crimp tube. Trim the short tail. 3. Let all beads fall down to the finished end. Check the fit on the bracelet and add or remove beads as needed. 4. On the unfished end of the bracelet thread on a crimp tube, three 11/0’s the button, and three 11/0’s. Go back down through the www.offthebeadedpath.net www.offthebeadedpathbeadstore.com crimp tube and pull the wire so that everything pulls down to the last drop added. 5. Using your crimp pliers crimp the crimp tube and trim the short wire. www.offthebeadedpath.net www.offthebeadedpathbeadstore.com
© Copyright 2024